Installation Materials

Low mounting boxes may be joined side by side by using a PMR474 interconnector, which must be cut to the height of the bottom of the box. Made of halogen free material (IEC/61249-2-21).

The PMR410 is 28 mm deep and is designed for use in, for example, brick walls.

The characteristics of this box are the same as the AU3.2; the difference is in the inlets. The box has 2 branch inlets for D20 conduits. There are also 3 knock-out on the side, and 2 on the bottom. Made of halogen free material (IEC/61249-2-21) and fulfills the requirements of the glow wire test according to the standard IEC/EN60670

The device offers the AU3.2 mounting box modified with a 28 mm deep extension ring for use in walls built of bricks that have pipe ducts. No branch inlets are required at the bottom of the box - straight access makes wire laying easier. There is no need to bend the conduits. Made of halogen free material (IEC/61249-2-21) and fulfills...

The box has 2 branch inlets with locking devices for D20 conduits. A separate inlet can be attached to the side opposite the fixed inlets. The bottom of the box has two inlets. Inlets cannot be attached to the sides of the box, but the sides can be used to connect boxes with each other using a PMR474 interconnector cut...

The PMR399 is 60 mm deep and is often used in renovating old houses, when adding 50 mm thermal insulation to inside walls while leaving existing conduit installations in place. The extension ring is attached to the old mounting box so as to extend it to the level of the new boarding.

If necessary, the box AU17.2 may be divided in two by using partition plate PMR345.

The PMR38 plug is also available separately for use with normal conduits. Made of halogen free material (IEC/61249-2-21).

A box is attached to its base from the inside with a PMR135 installation adaptor through the opened center blank. The screw-head is covered with the plug in the adaptor. The installation adaptor is used to eliminate any measurement errors made during panelling.

The AU8 junction box is 53 mm high and has eight inlets for Ø 20 conduits. The box also has knock-outs for 4 side inlets and 4 bottom inlets. In wall installation the box can be attached with a AS13 support. Made of halogen free material (IEC/61249-2-21) and fulfills the requirements of the glow wire test according to the standard...

The AS15 is designed to be used as a connector between AUS15.2 mounting boxes. Open needed knock-out holes on mounting boxes for the interconnector and install the boxes on the wall (board). Mount the interconnector in place from the inside of a box, to create a route for wires between boxes. Note

The junction box height can be increased by 13 mm by means of the AK7 extension ring. Screw distance c/c 78 mm.