Abb – 2TKA002742G1

The PMR490 interconnector is used to link together mounting boxes when groups of installation boxes that house weak and strong current circuits are installed under different coverplates. The centerplate distance of mounting boxes can be set at 85 mm when using a PMR490 interconnector. Made of halogen free material (IEC/61249-2-21).

The connecting piece PMR502 is used when low-voltage or strong-current circuit box groups are installed under different cover plates. With connecting piece PMR502, the distance between box centers is 100 mm. Made of halogen free material (IEC/61249-2-21).

Low mounting boxes may be joined side by side by using a PMR474 interconnector, which must be cut to the height of the bottom of the box. Made of halogen free material (IEC/61249-2-21).

If necessary, the box AU17.2 may be divided in two by using partition plate PMR345.

The AS15 is designed to be used as a connector between AUS15.2 mounting boxes. Open needed knock-out holes on mounting boxes for the interconnector and install the boxes on the wall (board). Mount the interconnector in place from the inside of a box, to create a route for wires between boxes. Note

Wall clamps offer a rapid means of attaching a mounting box to a 12-13 mm thick board wall. Wall clamp AS8.13 is available for 12 - 13 mm. The hole is made with an AT5 hole saw (Ø 74 mm), and the board clamps are placed on either side of the board. The box is pushed through the hole from behind the board, and becomes locked between the board clamps.

It is possible to raise the appliance up to 10 mm by using longer PLP5 screws. The screws fit all standard mounting boxes.

Truss fixture AS26.24 is used with the boxes AU60 and AU 60.1 in double board walls. The truss fixture includes nailing plate, which can also be attached using screws.

Truss fixture AS26.12 is used with the box AU5.5 in single and double board walls.With the boxes AU60 and AU 60.1 it is used in sigle board walls. The truss fixture includes nailing plate, which can also be attached using screws.

Support AS13.12 is used in wall installations with junction box AU8. By using the support, the open end of the box and the plate can be brought to the same level. Fits walls with 12 - 13 mm wall boards. Made of halogen free material (IEC/61249-2-21).

Interconnector AS8.3 is used when low-voltage or strong-current circuit box groups are installed under different cover plates. With interconnector AS8.3 the distance between box centers are either 85 mm or 100 mm depending on installation. Additionally, AS8.3 can be used as a inlet for 20 mm flexible conduit with AU80 -range boxes. Made of halogen free material (IEC/61249-2-21).